![]() With 151 million tonnes in 2022, Dutch ports also handled the largest volumes of dry bulk goods in the EU, followed by Spain with 103 million tonnes. Liquid bulk goods, such as crude oil and oil products, made up a substantial proportion of the inward tonnage.įigure 5: Gross weight of seaborne freight handled in main ports by type of cargo, 2022 Inward movements accounted for 62.2 % of the total tonnes of goods handled in the EU ports (Figure 4). ![]() Inward movements of goods to the EU countries increased by 4.7 % to almost than 2.2 billion tonnes in 2022 compared with 2021, whereas outwards movements decreased by 5.0 % to just under 1.4 billion tonnes. ![]() Montenegro, Türkiye and Iceland also reported noticeable increases: +151.9 %, +43.0 % and +21.3 %, respectively. Five other EU Member States registered growths higher than 24 % over the same period, while five additional countries recorded growths higher than 10 %. ![]() In contrast, Poland registered the largest relative increase (+102.2 %), followed by Romania (+52.5 %) and Malta (+47.0 %). In contrast, the highest relative falls were observed for Lithuania (-19.0 %) and Estonia (-15.5 %).Īll in all, only six Member States, recorded decreases in port freight activity in the ten-year period between 20. Montenegro also reported a noticeable increase of 57.6 %. If all you're doing is smaller holes, one of the smaller formats, not SDS-MAX, would probably be sufficient.Figure 3: Gross weight of seaborne freight handled in all ports, 2012, 20Īmong other countries reporting maritime freight data to Eurostat, the candidate country Türkiye handled 536 million tonnes of goods in 2022, placing this country between the Netherlands and Spain in terms of total tonnage of seaborne goods handled.Ĭompared with 2021, 15 out of 22 EU Member States registered a growth in port freight activity in 2022. I bought a replacement wide paddle bit from Bosch, in-case I broke the HFT one, it's still in my chest, waiting.ĭon't forget to fill the grease vault daily, and grease your flutes on the bits where they insert into the machine, if you want it to work well.Īs mentioned, I did use the HFT bits for my 1-car garage fastening the base plate, it took probably $100, so, call-it $300 out of pocket, that HFT paid for itself, and saved me $1,700. Here are some specs on the HFT hammer-drill SDS-MAX I have. I fired him after he ran another battery down, and tried to drive-in a pin after making maybe a 2-1/2" deep hole, and crooked at-that! He also was taking big chips out of the Hardi-Board siding, trying to use a pinch-bar to move the building (I had a crane to place the building, but he wanted to drop it on the slab before I put-down the mastic to seal between the walls' footer plates and the slab) for being bolted-down. ![]() The building sales owner said, "use this guy, he can do the securing to the slab." The guy showed-up with cordless DeWalt hammer-drills, crappy batteries, and no amount of changing from one crappy battery to another crappy battery did the job. I since have used it to drill 5/8" anchor holes for a premanufactured Hardi-Board sided garage placed onto a slab I had poured. It cost me under $100, but the regular price was about $140, it was on-sale, and they honored a 20%- coupon. I have one I bought for demo'ing two bathrooms. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |